Masonry Flashing Metal

K&M Sheet Metal specializes in the custom manufacturing of masonry flashing metal.

Parapet Wall Cap

Caps a parapet wall. Commonly used with hook strip on one side, both, or with a one piece hook strip system.

Z Flashing

Custom stainless steel Z flashing.

Masonry Drip Edge

A profile used to direct water / moisture away from a building. Normally flat with a kick and sometimes hem.

End Dams

Pre made as separate items, or part of full length items, these are used to seal the end of a part. Normally fabricated in stainless steel then soldered.

Masonry coping caps

Normally flat pieces with kicks on both ends to act as drip edges. Kicks may also feature hems.

Masonry Flashing Miters

Commonly made as separate pieces for profiles such as drip edge or through wall flashing.

Reglet

Used to counter flash areas. Most commonly used on chimneys. Features a kick / hook area to stay in place.

Step Flashing

Used to counter flash areas. Most commonly used on chimneys. Commonly made out of copper and stainless steel.

Through Wall Flashing

Common profile used on brick building to expel any water that has made its way past the bricks.

90° Angle Flashing

L shaped flashing in 90 degrees, or custom angles.

Window and Door heads

Profiles used on divert any water form the top of a window or door away.

Window and Door Jambs

Profiles used on the installation of windows and doors to direct water away from a structure.

Window and Door Sills

Profiles used to direct any water that made its way behind doors or windows away.